Add to Cart:

Yorkshire Grit - Microfine

R415.00

A hand blended mix of mineral oil, beeswax and microfine abrasive powders designed to leave a highly polished surface on resins, hybrids and wood.

Recommended Instructions For Use:

Best results are achieved by using original Yorkshire Grit Woodturners Abrasive Paste prior to Microfine,
if this is not possible then sand to at least 600 grit ensuring you have a flawless even surface.

If you are using Microfine directly after dry sanding apply a thin sanding sealer, leave to cure and de-nib.

With the lathe stationary use a paper towel to apply a small amount of the paste to the workpiece working
it into the grain until uniform coverage is achieved.

Start the lathe at a slow speed approx. 500rpm or less and using the same applicator work the paste into
the wood for a minute or two. Depending on the material you are abrading you may need to top up the paste
on the applicator towel until the desired finish is achieved.

Once you are satisfied with the level of finish use a clean paper towel to keep moving across the area with
moderate pressure and increasing rpm until the residue stops showing on the towel, for hybrids and resin
pieces you are now ready for the buffing if you are aiming for a glass clear finish. Wooden pieces are now
ready for your preferred finish.

Please note:

Care should be taken to ensure all Microfine residue is removed prior to using any lacquer based finishes.

  • Model: Yorkshire Grit
  • Shipping Weight: 282grams
  • 8 Units in Stock


This product was added to our catalog on Thursday 24 January 2019.

Copyright © 2019 Mr Woodturner